IBM eServer xSeries 440 Installation Manual page 20

3. Refer to the documentation that comes with your adapter for any cabling
4. Set any jumpers or switches as described by the adapter manufacturer.
5. Install the adapter:
6. Connect the internal cables to the adapter.
7. If you have other options to install or remove, do so now.
8. Go to "Completing the installation" on page 24.
10
xSeries 440: Installation Guide
dealer or through IBM at http://www.ibm.com/.
Adapter guide
instructions.
Note: Route adapter cables before you install the adapter.
a. Open the blue adapter guide by lifting the front edge, as shown in the
illustration.
b. Carefully grasp the adapter by its top edge or upper corners, and align it
with the connector on the I/O board.
c. Press the adapter firmly into the adapter connector.
Attention: When you install an adapter, be sure the adapter is correctly
seated in the connector before you turn on the server. Improperly seated
adapters might cause damage to the I/O board or to the adapter.
d. Push down on the blue adapter guide to keep the adapter steady.
e. Close the tab; then, push down on the blue adapter retention latch until it
clicks into place, securing the adapter.
Tab
PCI-X
divider
Attention
LED
Power
LED
Adapter
retention
latch