7. Being careful not to damage the components on the center plane, use the
8. Remove the SMP Expansion Module cover:
16
xSeries 440: Installation Guide
Note: The illustrations in this document might differ slightly from your hardware.
Latch
handle and the finger relief on the SMP Expansion Module cover to lift the SMP
Expansion Module out of the server.
a. Place the SMP Expansion Module on a flat, level surface.
b. Rotate the two locking levers until they are fully extended beyond the edge
of the SMP Expansion Module cover. Do not force the locking levers past
the position shown in the illustration.
Cam
Locking
levers
Finger relief
Handle