IBM System/36 5360 Manual page 146

......
_...
134
9. Identify and relabel each cable, if necessary:
Look at each cable to be sure that the label is still attached to
it. If not, make a label.
If you need longer work station cables at your new location,
order these as soon as possible, as described in Planning to
Set Up Your Computer: Workbook 3.
CAUTION: The cable and cable connectors are durable, but
can be damaged if stepped on or thrown.
10. Disconnect each cable.
a.
b.
c.
d.
To disconnect the work station cables, turn the retaining
ring counterclockwise until it is loose; then, pull the
cable out.
Coil each cable and wrap it with tape.
To disconnect the communications cable(s), perform the , /
following steps:
•
Open the work station port panel.
•
Do
EID
and
llEJ
in reverse order/
, ,
To disconnect the 3262 Printer, do the following :
,
,
, ,
, ,
, ,
,
,
,
,
,
, ,
, ,
, ,
,
For information on making labels, see Preparing
to Receive Your Computer: Workbook 7.
Push the plastic retainers in while pulling on the
,/communication cable connector .
• Open the work station port panel. ----
Do not do step D if your 3262 Printer is not a
------- customer setup model. (You can tell by
• Do
ED
through
am
in reverse order.------
reviewing
ED
in this manual. If your 3262
Printer is not a customer setup model, call your
hardware service representative to disconnect
your 3262 Printer.)
111111_...Section 7 Continued