Table of Contents
Advertisement
WARNING!
●
Never start or run the engine with the
vehicle on a jack.
●
Do not let anyone sit in the vehicle when it is
on a jack.
●
Do not get under the vehicle when it is on
a jack. If you need to get under a raised
vehicle, take it to a service center where it
can be raised on a lift.
●
Only use the jack in the positions indicated
and for lifting this vehicle during a tire
change.
●
If working on or near a roadway, be
extremely careful of motor traffic.
●
To assure that spare tires, flat or inflated,
are securely stowed, spares must be stowed
with the valve stem facing the ground.
Jack Warning Label
1.
Remove the spare tire, jack and tools from
the stored location.
2.
Loosen (but do not remove) the wheel lug
nuts by turning them to the left one turn
while the wheel is still on the ground.
3.
Assemble the jack and jacking tools.
Connect the jack handle driver to the
extension, then to the lug wrench.
Assembled Jack And Tools
NOTE:
If your vehicle comes with factory equipped
35 inch (88.9 cm) tires, a jack lift block is
provided in the rear cargo area. The jack
lift block is used to provide higher ground
clearance when changing a flat or spare tire.
When placing the jack lift block under the
jack, be sure the bottom of the jack fits
securely inside of the raised edges of the
block.
EMERGENCY
61
Advertisement
Table of Contents
