Table of Contents
Advertisement
Available languages
Available languages
TROUBLESHOOTING GUIDE
if the unit fails to perform as described in these operating
instructions, 'check the following guide.
GENERAL
There is no sound.
* Is the AC cord connected properly?
* is there a bad connection? (+ page 8)
* There may be a short circuit in the speaker terminals.
—
Disconnect
the AC cord, then correct the speaker
connections.
= Was an incorrect function button pressed?
Sound Is emitted from one speaker only.
+ fs the other speaker disconnected?.
(+ page 8)
The output sound is not stereo.
+ Is the Karaoke function turned on? (> page 40)
TUNER SECTION
There is constant, wave-like static,
* Is the antenna connected property? (— page 8)
* Is the signal weak?
— Install an outdoor antenna. (+ page 8)
The reception contains noise interferences or the sound is
distorted.
* Is the system picking up extemal noise or multipath distortion?
— Change the orientation of the antenna. (+ page 6)
> Move the unit away from other electrical appliances,
CASSETTE DECK SECTION
The tape does not run.
Is the deck in pause mode?
(— page 26)
The sound is off-balance or not adequately high,
* Is the playback head dirty? (+ page 48)
Recording is not possible.
* Is the erasure prevention tab on the tape broken off? (> page
+ Is the recording head dirty? (— page 48)
Erasure Is not possibile.
+ Is the erasure head dirty? (+ page 48)
+ is a metal tape being used? (> page 30)
High frequency sound is not emitted.
+ Is the recording/playback head dirty? (-+ page 48)
CD PLAYER SECTION
The CD player does not play.
* Is the disc correctly inserted? (- page 16)
* Is the disc dirty? (— page 48)
« Is the lens affected by condensation?
— Wait approximately one hour and try again.
The disc tray does not close even if the
© OPEN/CLOSE
button is pressed,
* Has more than one disc been placed on one disc tray?
— Remove the discs and reset the unit.
To reset
If an unusual! condition occurs in the display window or the
cassette decks, reset the unit as follows.
1 Press the POWER button to turn off the power.
2 Press the POWER
button to turn the power back on while
pressing the ll CLEAR button. Everything stored in memory
after purchase is canceled.
If the power cannot be turned off in step 1 because of a
maifunction, reset by disconnecting the AC cord and repeat
step 2.
Advertisement
Table of Contents
