Photo Burst - Minolta MN5KGP1 Manual

. Using Your Camcorder
2.7

Photo Burst

In photo burst mode, the camcorder will take a set number of images with
each press of the SHUTTER button.
To enter Photo Burst mode, power the camcorder on and press the
POWER/MODE button to access the mode selection screen and use the UP
or DOWN buttons to select Photo Burst icon and press the OK button to
enter that mode.
1. Line up your shot by looking at the LCD screen to see what is in the shot.
2. Hold the camcorder steady and press the SHUTTER button to capture a
photo.
3. The number of photos that can be captured at a particular resolution will be
displayed in the bottom right corner of the screen.
4. The number of pictures remaining will be 0 if there is no memory card
will be shown at the screen when the memory card is full.
5. The number of remaining photos is determined by the selected photo
resolution. The higher the photo resolution, the lower the number of photos
you are able to be save to the memory card. Before capturing any photos,
you can select a preferred photo resolution.
Your camcorder comes preset with some user-adjustable settings to fine tune
and customize how you would like your videos to be captured. The settings
are already optimized and preset for the easiest experience.
From the main screen, press and hold the OK button until you see the
settings menu on the screen. You can also tap the screen and then select
the gear icon that shows on the screen to access the settings.
2.7.1 Photo Burst
This function lets you set the number of photos captured with each photo
burst.
1. In Photo Burst Mode press and hold the OK button.
2. Select Photo Burst using the UP or DOWN buttons.
3. Press the OK button to enter the Photo Burst submenu.
37