Basic settings
PC Module On/Off
If the product is installed with the optional PC module and it is in the "PC" signal source, the PC module will
start automatically. If not, start it manually by pressing the power button on the PC Module.
The power key on the panel or remote control can be used to turn off the display, the display will request
confirmation to proceed.
Do not directly disconnect the power supply from the display without turning off the PC module as it can
damage the PC module.
Signal Source Switching
You can use the remote control or touch function to switch the source by the following methods:
Method one:
• Press the icon in the upper right side of the screen that looks like a laptop screen with arrows (fig.1)
• Select the signal source and then the product will switch to the input signal source you selected.
Method two:
• Press the "Input" key on the remote controller to open the "Input mode menu"
• Press the cursor keys on the remote control to select a signal source
• Press the"OK" key, and then the product will switch to the input signal source that you selected.
Method three:
• Swipe up from the bottom of the screen to open the "input" menu. (fig.2)
• Select the signal source and then the product will switch to the input signal source you selected.
25
InFocus - JTouch 50 Hardware Guide
Note
The PC Module is an optional purchase
infocus.com | Always InFocus
.