Advertisement
MI LOCATION
OF CONTROLS
Input selector display
Shows the sound source selected by the input selectors.
Loudness indicator (loudness)
indicators
(power level)
Volume/balance level indicators (volume/balance)
These indicators usually show the volume level; when the balance control is pressed,
however, the position of balance level is displayed for five seconds, after which the display
These indicators indicate the peak
returns again to indicate of the volume level. When the muting button (on the remote-
power value of the output level to.
control transmitter) is pressed, the indicator corresponding to the maximum displayed
the speaker systems.
volume level point will flash.
When the power switch is set to the "on" position the tip of these levels controls will illuminate.
Volume controls
(volume)
Power switch (power)
Power indicator (power)
When the power switch is set to the "on" position, this in-
dicator illuminates to indicate that the unit is in operation
Input selectors (input selector)
These selectors are used to select the sound source to
be heard, such as a disc, radio broadcasts, etc.
The select sound source shows on the input selector
display.
Headphones jack (phones)
Speaker selectors (speakers)
These selectors are used to turn the speaker
systems on and off.
Loudness switch (loudness)
Set to the "on" position when listening to music at low volume!
Tape-monitor switch (monitor)
low volume, but when the switch is in this position, this deficiency is
No other sources selected by the input selector can be heard
compensated for, so that the full impact of the musical performance
while the tape indicator is illuminated. To listen to some other
can be enjoyed.
source, press this button once again.
Advertisement
