Rear Panel - Omega COMPACT CAL CA100 Owner's Manual

Terminal Side
1 RJC sensor input connector
This connects to an RJC sensor (optional).
2 24 V output terminal
This supplies 24 V DC power.
3 Current input terminal
This is used when measuring current.
4 Voltage/resistance input terminal
This is used when measuring voltage or resistance.
5 Output terminal
This outputs the specified source.
This instrument falls under Overvoltage category II (CAT II). Overvoltage
(installation) category indicates the impulse withstand voltage level which is regulated
by IEC1010-1.

Rear Panel

1 Battery storage
This holds the attached dry cells or the optional Ni-Cd battery pack.
• Before turning on the power switch, make sure the battery
24V OUT MEASURE SOURCE
Hi Hi
mA
FUSE 28V
22mA MAX 42V MAX MAX
R.J. INPUT 250V F 125mA 22mA
Lo Lo
ALL TERMINALS 42V
120mA MAX
PEAK MAX TO GND.
1 2 3 4 5
1
CAUTION
housing is shut with the cover on properly. Do not open the
cover while the instrument is in operation.
13
Free Datasheet http://www.datasheet-pdf.com/