Appendix; Specifications - Yamaha MG8/2FX Owner's Manual

Appendix

Appendix
Specifications
■ Electrical Characteristics
Total Harmonic Distortion
(MIC to ST OUT)
Frequency Response
(MIC to ST OUT)
Hum & Noise (20 Hz - 20 kHz)
Rs=150 ohms, Gain=Maximum,
Sensitivity=–60 dBu, Hum & Noise are measured
with a –6 dB/octave filter @12.7 kHz;equivalent to
a 20 kHz filter with infinite dB/octave attenuation.
Maximum Voltage Gain
PAN/BAL : panned hard left or hard right.
Crosstalk (1 kHz)
Monaural/Stereo Input GAIN Control
Where 0 dBu = 0.775 V
■ General Specifications
Monaural/Stereo CH High Pass Filter
Monaural/Stereo CH Equalization
Turn over /roll-off frequency of shelving, 3 dB below maximum
variable level
Internal Digital Effect
Phantom Power
Monaural/Stereo Input PEAK Indicator
Level Meters
Included Accessories
Options
Power Consumption
Dimensions (W × H × D)
Weight
Where 0 dBu = 0.775 V
22
MG8/2FX
Conditions
(THD+N) 20 Hz - 20 kHz @+14dBu 10k ohms (CH1, 2) with
Signal input CH LEVEL Control and ST Master LEVEL Con-
trol at nominal level
20 Hz - 20 kHz @+4 dBu 10k ohms with GAIN control at min-
imum level
Equivalent Input Noise (CH1, 2)
Residual Output Noise (ST OUT)
ST Master Control at nominal level and all CH LEVEL Control at
minimum level. (ST OUT)
All CH EFFECT Control at minimum level and all CH LEVEL
at minimum level. (EFFECT SEND)
ST Master Control and one CH LEVEL Control at nominal
level. (CH1, 2) (ST OUT)
CH MIC INPUT to CH INSERT OUT
CH MIC INPUT to ST OUT
CH MIC INPUT to REC OUT
CH MIC INPUT to EFFECT SEND
ST CH MIC INPUT to ST OUT
ST CH LINE INPUT to ST OUT
ST CH LINE INPUT to EFFECT SEND
ST CH INPUT to ST OUT
RETURN to ST OUT
2TR INPUT to ST OUT
Adjacent inputs
input to output
variable range
80 Hz 12 dB/octave
±15 dB (Max. Variation)
HIGH: 10 kHz (shelving)
MID: 2.5 kHz (peaking)
LOW: 100 Hz (shelving)
16 programs, Parameter control
FOOT switch (ON/OFF)
Supplied when Phantom +48 V switch is ON. (XLR-type input jacks)
On each channel: red indicator lights if post-EQ signal (on ST channels, if either post-EQ
signal or post-mic-amp signal) comes within 3 dB of the clipping level.
Two 12-points LED level meters [ST (L, R)]
Peak point: red indicator
+5, +3, +1, 0: yellow indicators
–1, –3, –5, –7, –10, –15, –20: green indicators
Power adaptor (PA-10)
Microphone-stand adaptor (BMS-10A), Footswitch (FC5)
25 W
251 mm × 65 mm × 290.5 mm
1.8 kg
MIN TYP MAX
0.1
–3 0 1
–128
–100
–87
(91 dB S/N)
–85
(89 dB S/N)
–64
(68 dB S/N)
60
76
64.2
70
76
50
41
26
12
23.8
–70
–70
44
UNIT
%
dB
dBu
dBu
dBu
dBu
dBu
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB
dB