Table of Contents
Advertisement
WLAN module
Description
Intel Dual Band Wireless-AC 7265 802.11 ac 2x2 WiFi + Bluetooth 4.2 Combo Adapter (non vPRO)
CAUTION:
To prevent an unresponsive system, replace the wireless module only with a wireless module
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the following components:
a.
Battery (see
b.
Optical drive (see
c.
Base enclosure (see
Remove the WLAN module:
1.
Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
2.
Remove the Phillips M2.0 x 2.5 screw (2) that secures the WLAN module to the system board. (The WLAN
module tilts up.)
Battery on page
Optical drive on page
Base enclosure on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1".
34)
35)
37)
Spare part number
793840-005
Component replacement procedures
45
Advertisement
Table of Contents
