Service; Battery Replacement - Graco Pulse 26C935 Installation And Operation Manual

Metered dispense valve
Table of Contents

Advertisement

Service

Battery Replacement

Replace batteries with four AA, alkaline
batteries.
Follow the correct polarity, as shown
on the installation labels located on
either side of the metered dispense
valve, when installing batteries in the
battery compartment (F
Do not mix different types of batteries
together or old batteries with fresh.
Always replace all 4 batteries with four,
fresh, new AA batteries.
To change the batteries:
1.
Remove the screws (36) from the battery
compartment cover (5).
2.
Using a small, flat screwdriver, gently
pry the cover away from the metered
dispense valve housing on the bottom
side of the cover near the extension
attachment as shown in F
F
. 50
IG
3.
Remove and recycle batteries
according to all applicable regulations.
Do not dispose of the batteries with
household or commercial waste.
3A7397E
. 51).
IG
. 50.
IG
36
5
4.
Install four new batteries. See the labels
on the each side of the housing and F
51 for battery orientation.
F
. 51
IG
5.
Replace the cover (5) and screws (36).
Do not over-tighten screws (F
36
5
F
. 52
IG
Service
.
IG
. 52).
IG
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pulse 26c936

Table of Contents