Table of Contents
Advertisement
Assembling the upstand
The upstand must always be positioned and
secured correctly on the appliance.
1. Loosen the 2 screws (A) on the back of the
hob using a screwdriver (only loosen the
outermost ones).
2. Place the upstand on the hob.
3. Align the slots of the upstand (B) with the
screws (A).
The upstand provided is an integral part
of the product. It must be fastened to the
appliance prior to installation.
Fastening to the wall
The symbols above indicate the danger if the
anti-tip are not installed devices and the
importance of their correct installation.
The anti-tip devices must be installed in
order to prevent the appliance from
tipping over.
1. Screw the wall fastening plate to the rear of
the appliance.
2. Adjust the height of the 4 legs.
32 - INSTALLATION
3. Assemble the fastening bracket.
4. Align the base of the hook on the fastening
bracket with the base of the slot on the wall
fastening plate.
5. Align the base of the fastening bracket with
the ground and tighten the screws to fix the
measurements.
6. Consider a distance of 50 mm from the side
of the appliance to the bracket holes.
91477A747/B
Advertisement
Table of Contents
