Cleaning The Oven Cavity - Smeg CSP9GMXA2 Manual

kitchen roll. In case of stubborn dirt, wash
with a damp sponge and neutral detergent.
7. When you have finished cleaning, reinsert
the intermediate glass pane in its housing in
the door.
8. To reposition the internal glass pane, slide
the upper part into the door strip and insert
the two rear pins into their seats by pressing
lightly.

Cleaning the oven cavity

In order to keep your oven in the best possible
condition, clean it regularly after letting it cool
down.
Avoid letting food residue dry inside the oven
cavity, as this could damage the enamel.
Take out all removable parts before cleaning.
For easier cleaning, it is recommended to
remove:
• the door;
• The rack/tray support frames.
In the event you are using specific
cleaning products, we recommend
running the oven at maximum
temperature for 15-20 minutes in order
to eliminate any residue.
Drying
Cooking food generates moisture inside the
appliance. This is a normal phenomenon and
does not affect the appliance's operation in any
way.
Each time you finish cooking:
1. Let the appliance cool down.
2. Remove any dirt from inside the appliance.
3. Dry the interior of the appliance with a soft
cloth.
4. Leave the door open until the inside of the
appliance has dried completely.
Removing racks/trays support frames
Removing the rack/tray support frames enables
24 - CLEANING AND MAINTENANCE
the sides to be cleaned more easily.
To remove the rack/tray support frames:
• Pull the frame towards the inside of the oven
cavity to unhook it from its groove A, then
slide it out of the seats B at the back.
• When cleaning is complete, repeat the
above procedures to put the rack/tray
support frames back in.
Vapor Clean cycle setting
1. Turn the functions knob to symbol
(where present).
2. Turn the temperature knob to the
symbol.
3. Allow the cleaning cycle to run for 18
minutes.
Pyrolytic function setting
1. Turn the function knob to
appears on the display, alternating
with the duration of the Pyrolytic cycle
(factory set to 2 hours 30 minutes).
2. Press the increase
buttons to set the duration of the Pyrolytic
cycle.
Recommended pyrolytic cycle duration:
• Light dirt: 2:00
• Medium dirt: 2:30
• Heavy dirt: 3:00
3. Press the clock button
settings.
The preheating for the Pyrolytic cycle starts after
a few seconds:
• the symbol on the display and the
Pyrolytic cycle light come on;
• the display shows the time left until the end
of the cleaning cycle
• the symbol on the display flashes.
A few minutes after preheating starts, the
or
.
and decrease
to confirm the
;
91477A747/B