Maintenance; Technical Data - Husqvarna DH110 Operator's Manual

5. Release the lock buttons at the 2 sides.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To do general maintenance
To clean and lubricate the blades
1. Clean the blades from unwanted materials before
and after you use the product.
2. Lubricate the blades before long periods of storage.
Note:
Speak to your servicing dealer for more
information about recommended cleaning agents and
lubricants.

Technical data

110iLD or 110iL + Hedge trimmer attachment DH110
Weight
Weight without battery, kg
Blades
Type
Cutting length, mm
Cutting speed, cuts/min
Noise emissions
Sound power level, measured dB (A)
Sound power level, guaranteed L
1
Noise levels
Sound pressure level at the operator's ear, measured according to EN 62841-4-2
dB(A)
Equipped with approved accessory (original)
1
Noise emissions in the environment measured as sound power (L
2000/14/EC. The difference between guaranteed and measured sound power is that guaranteed sound power
also includes dispersion in the measurement result and the variations between different products of the same
model refer to Directive 2000/14/EC.
10
6. Move the housing up and down until the cutting

Maintenance

To examine the blades
1. Clean the blades from unwanted materials with an
2. Examine the edges of the blades for damages and
3. Use a file to remove burrs on the blades.
4. Make sure that the blades can move freely.
Technical data
dB (A)
WA
attachment locks in position.
anti-corrosion cleaning agent before and after you
use the product.
deformation.
3.81
Double-sided
560
2800
87
90
80
) in conformity with EC directive
WA
2206 - 004 - 26.10.2023