Maintenance - Husqvarna 325iR Operator's Manual

2. Push the stop button. (Fig. 45)
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.

Maintenance

Clean the external parts of the product with a dry cloth. Do not use water.
Examine that the start and stop button works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Keep the handles dry, clean and free from oil and grease.
Make sure that the cutting attachment is not damaged. Replace the cutting
attachment if it is damaged.
Make sure that the cutting attachment guard or knife is not damaged. Replace
the cutting attachment guard or knife if it is damaged.
Make sure that the screws and nuts are tight.
Make sure that the battery release buttons on the battery works and locks the
battery in the product.
Examine that the battery charger is not damaged and function correctly.
Make sure that the battery is not damaged.
Make sure that the suspension point is not damaged.
Make sure that the handle and the handlebar is not damaged and attached
correctly.
Make sure that the blade is correctly centered, is sharp, and not damaged. An
off-center blade will cause vibration that could result in damage to the product.
Make sure that the locknut of the cutting equipment is tightened correctly.
Make sure that the transport cover for the blade is not damaged and that the
transport cover can be attached correctly.
Examine all couplings and connections. Make sure they are not damaged and
free from dirt.
Make sure that the bevel gear is filled correctly with grease, see
bevel gear on page 20 . If not, use Husqvarna bevel gear grease.
Make sure that the air intake of the motor is not dirty. Clean the air intake with
compressed air.
1859 - 005 - 21.09.2023
Maintenance
Before you do any
3. Push the release buttons on the battery and pull the
battery out. (Fig. 51)
Maintenance schedule
WARNING:
you do maintenance.
The following is a list of the maintenance steps that you
must do on the product.
To lubricate the
Remove the battery before
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
19