Maintenance - Husqvarna TA320 Operator's Manual

Introduction
Below you will find some general maintenance
instructions. If you need further information
please contact your service workshop.
To perform maintenance on the
attachment
• Do the daily maintenance tasks for the
power unit. Refer to the operator's manual
for the power unit.
To extend the trimmer line
• When the trimmer line becomes short
during operation, tap the trimmer head on
a hard, flat surface to extend more trimmer
line. You must operate the product at full
speed to get the best result.
10

Maintenance

To replace the trimmer line
1. Hold the lower half (A) of the trimmer head
with one hand. Turn the top half (B) of the
trimmer head clockwise with your opposite
hand.
A
Note:
trimmer head, you will hear a click.
2. Continue to turn the top half of the trimmer
head until the triangle (C) aligns with the
hole (D).
3. Pull out and discard the remaining trimmer
line.
4. Cut approximately 22 ft (6.7 m) of new
trimmer line.
5. Put 1 end of the trimmer line into 1 of the
holes.
When you turn the top half of the
2119 - 001 - 13.07.2023
B
C
D