Mounting The Center Speaker - Yamaha NS-P400 Owner's Manual

Mounting the effect speakers
Mount the effect speakers on a shelf, rack or on the floor
directly, or hang them on the wall.
To mount the effect speakers on a wall
The speakers can be mounted on a wall by using the holes
provided on the speakers' rear panels.
Fasten screws into a firm wall or wall support as shown in the
diagram, and hang the holes on the rear of the speaker on the
protruding screws.
* Make sure that the screws are caught by a narrow part of
the holes securely.
Holes

Mounting the center speaker

Place the center speaker on top of the TV or on the floor under
the TV or inside the TV rack so that it is stabilized.
When placing the speaker on top of the TV, to prevent the
speaker from falling down, put the provided velcro strips at two
points on both bottom of the speaker and top of the TV.
1
Velcro
strip
TV set
2
WARNING:
• Each speaker weighs 1.6 kg (3 lbs. 8 oz.). Do not mount
them on thin plywood or soft wall surface material, as
the screws may come out of the flimsy surface, causing
the speakers to fall down and be damaged, or result in
personal injury.
• Do not fasten the speakers to wall with nails, adhesives,
or other unsound hardware. Long-term use and
vibrations may cause them to fall down.
• To avoid accidents resulting from tripping over loose
speaker cords, fix them to the wall.
Diam. 4 – 5mm
Min.
12mm
2mm
Tapping screw (Available at the
hardware store)
Notes
• Do not place the speaker on top of the TV whose area is
smaller than the bottom area of the speaker. If placed,
the speaker may drop out causing an injury to you.
• Though this speaker is a magnetically shielded type,
there may be some influence on a TV picture depending
on the type of TV or the placement of the speaker. In
such a case, place the speaker apart from the TV so that
there is no influence on TV picture.
40mm
Screen
7