Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Yamaha NS-PA40
Summary of Contents for Yamaha NS-PA40
- Page 1 (NS-F40 + NS-C40 + NS-B40 + NS-SW40) SPEAKER PACKAGE OWNER'S MANUAL...
- Page 2 Precautions Please read the following operating precautions before use. Yamaha will not be held responsible for any damage and/or injury caused by not following the cautions below. 1. To assure the finest performance, please read this 1. Do not operate this unit upside down. It may overheat, manual carefully.
-
Page 3: Table Of Contents
If this product doesn’t work as expected, look for a possible cause in the troubleshooting section on page 7. If the issue you are experiencing is not listed, or you cannot resolve it after reading through these instructions, disconnect the power cable and contact an authorized Yamaha dealer or service center. -
Page 4: Package Contents
Package contents • Make sure that all parts are included in the package. • Pay attention not to drop the bases when you take them out of the box. Front speaker (NS-F40) x2 Subwoofer (NS-SW40) x1 Surround speaker (NS-B40) x2 Bottom Center speaker (NS-C40) x1... - Page 5 Assembling the front speakers Attach the Base to the Bottom. 1 Insert the three projections on the Base into the Projection three holes on the lower end surface of the Base Base Bottom. Make sure that the notch on the Base faces in the same direction as the rear panel of the Bottom, which includes a groove for a speaker cable.
-
Page 6: Installing The Speakers
Installing the speakers Before you connect the speakers, place each speaker in Installing the subwoofer its respective location. Speaker positioning is very important as it affects the overall sound quality of the Place the subwoofer on the outside of either the right system. -
Page 7: Connecting The Speakers
Connecting the speakers Warning Wall/wall NS-B40 support • Do not mount the speakers on thin plywood or on a 0.59 kg wall with a soft surface material. Otherwise, the (1.30 lbs.) screws may pull out of the surface and the speakers may fall, possibly damaging the speakers or causing 6 mm (1/4") - Page 8 Connecting the speakers ■ Preparing the speaker cables ■ For the front speakers Once you’ve positioned the speakers, you’ll need to cut After connecting the cable, fit it into the the 24.5-meter (80 ft.) speaker cable to make five groove on the rear panel of each Bottom. cables for connecting the two front speakers, center speaker, and the two surround speakers.
-
Page 9: Connecting The Power Cables
Using the Subwoofer Caution In your AV receiver’s speaker size settings, specify small (or “S”) for all of the NS-PA40 speakers. • To move the front speaker to another location, grasp both the Base and Bottom. If you’re connecting the subwoofer to a Yamaha DSP •... -
Page 10: Troubleshooting
Driver NS-F40 ■ Subwoofer (NS-SW40) Woofer........7 cm (2-3/4") cone type x2 Type ....Advanced Yamaha Active Servo Technology II Tweeter......2.5 cm (1") balanced dome type Driver ..........16 cm (6-1/2") cone woofer NS-C40..........7 cm (2-3/4") cone type non magnetic shielding type NS-B40 .......... - Page 11 Information for Users on Collection and Disposal of Old Equipment This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/...
- Page 12 Printed in Indonesia ZC88810 © 2012 Yamaha Corporation...