Lincoln Electric IDEALARC DC-600 Service Manual page 107

F-63
TRANSFORMER REMOVAL FROM LIFT BAIL ASSEMBLY PROCEDURE
6. Remove the four self-tapping bolts that hold
the Lift Bail to the transformer base using a
9/16" socket wrench. See Figure F.22.
NOTE: There is one bolt on each side of the trans-
former that must be removed by inserting
the wrench through the hole in Lift Bail.
7. Remove the Lift Bail and Output Bridge
Assembly from the transformer by lifting the Lift
Bail up slightly and sliding the Lift Bail towards
the SCR Bridge.
TROUBLESHOOTING AND REPAIR
(continued)
IDEALARC
TRANSFORMER DISASSEMBLY
1. Identify and label all leads to the transformer.
2. Cut or unsolder all leads.
a. Cut the secondary leads. These must be
re-TIG welded to the new transformer
coils.
3. Remove the four nuts from the through bolts
that hold the transformer together.
4. Attach a hoist to the top of the E Iron and lift
from assembly.
® DC-600
F-63