Optional Icemaker Requirements (Tr-30Frz/36Frz-Imc) - True RESIDENTIAL TR-30 Install Manual & User Manual

OP TIONAL ICEM AKER REQUIREMENT S
( TR-30FR Z/36FR Z-IM-C)
WAT ER SUP P LY R EQUIR EMEN T S
WA R NING! ONLY C ONNEC T YOUR
A P P L I A NCE T O A P O TA BL E WAT ER
SUP P LY.
Units with optional ice makers come with 20" (508 mm)
of polyethylene tubing with a 1/4" O.D. push connector
for customer attachment.
Before installing your unit, prepare the water supply
line. Please see plumbing requirements in the plumbing
requirements table.
• Purge the water line prior to final connection to the
unit. This removes any debris present in the line.
• Only connect to a potable water supply!
• Do not connect to a hot water supply!
• Install the water filter before turning on the water
supply to the icemaker. See "Water Filter Installation"
(pg 17).
• A copper line is not recommended for this
application.
• Check all water line fittings for leaks.
• Tape the supply line to the floor before moving the
unit into its final installation location.
• In the water connection area (see the rough opening
illustration), tape the water line to the floor.
Page 16 of 80
T RUE RE S ID E N TI A L
P R I O R T O I N S T A L L A T I O N
P A G E T I T L E
FIG. 1.
Water Supply
Flow Rate
Operating Pressure
Incoming Water Temperature
10/06/2023
®
Water line connection. Fitting included, PEX not included
Plumbing Requirements
1/4" PEX tubing (1/4" O.D. lines
and fittings not included
NOTE: Copper line is not
recommended
0.5 gpm / 1.89 lpm
30-100 psi (207-689 kPa)
33-100°F (0.6-38°C)
ELECTRICAL AREA
WATER AREA
NOTE: Dimensions may vary by ± 1/8" (3.175 mm)
# 2125 3 0 TEC_TM_009 REV. J_EN