Table of Contents
Advertisement
a
";
Before Requesting
Service
Power
Correction
* Completely
insert Power Plug into an AC outlet.
e Set POWER
button to on.
+ Make sure power source is active.
Correction
* Check connections between VCR, extemal antenna, and TV.
e Check connections selection. (P.8, 17
+
Make sure your antenna system (CABLE or TV) is correctly
set. (Channels [P.10))
e
Make sure cassette record tab is intact. (P.4)
+ Confirm that clock is set to current time and date.
* Make sure Cable/DSS box (if used) is left on and tuned to
channel to be recorded.
» Set recording start/stop times correctly. (P.14)
«
Make sure VCR POWER button is pressed off. ae
« Timer recording may not be performed or continued if a power
interruption occurs before or during a Timer Recording, even
after power is restored.
Select channel 3 or 4 on TV to match VCR output channel (3
or 4) (P.8) or select LINE.
. Sat VCR/TV selector to "VCR."
* Adjust TRACKING control in either direction. (P.25)
. Try Head Cleaning. (P.25
¢ Set TV's Vertical Hold Control to MANUAL, then adjust.
Make sure VCR power is on.
Check Remote batteries.
Make sure VCR LOCK is set to off. (P.23)
Make sure Remote is in proper mode.(P.16)
Make sure Timer Record is not in progress.
Correction
Make sure VCR power is on.
Make sure Remote is in VCR mode.
Aim Remote Control directly at remote sensor on VCR. (P.6)
Avoid any object blocking signal path.
Check Remote batteries. (P.4)
Make sure VCR LOCK is set to off. (P.23)
Exposing VCR remote sensor to direct fluorescent or outdoor
light may cause signal interference.
:
Check connections between VCR, externa! antanna, and TV.
e Press VCR button for VCR mode, (P.16)
Check Remote batteries. (P.4)
No power...
Recording 8 Playback
TV program cannot be recorded...
Timer recording cannot be performed...
There is no playback picture, or the playback
picture is noisy or contains streaks...
Special effects playback, picture may
contain some vertical jitter when using a TV
with an Automatic Vertical Hold Control...
VCR cannot be controlled...
Remote Control
VCR cannot be remote controlled...
ACTION and PROG buttons do not respond...
Miscellaneous
Correction
. Make sure TV power is on.
+ Make sure TV is set to output of VCR.
« Check connections between VCR, external antenna, and TV.
« Set VCRITV selector to "TV." (P.13)
e Make sure proper signal source is selected.
Programs cannot be viewed on TV...
+» Insert the cassette with window side up; record tab facing you.
Video cassette ejects when a recording is started].
Make sure cassette record tab is intact. (P.4)
or the power is tumed off for timer recording
« To enable Quick play mechanism, the cylinder will rotate for
eee
(CYLINDER)
about 3 minutes. This reduces response time from Stop to
7
Play mode and from Play to Rewind Search mode.
=]
—h
Q
=
=|
SD
ae
je,
=
If you cannot resolve the problem, please call the Customer Cail Center for product
assistance at 1-800-211-PANA (7262).
or send e-mail to : consumerproducts
@ panasonic.com
27
Inoq
104
Advertisement
Table of Contents
