Table of Contents
Advertisement
For Model VHQ-451 only
$
VIDEO OUT
AUDIO IN
y" Y
VIDEO IN
For Model VHQ-401 only
Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on Recording VCR. To
monitor the dubbing, also connect a TV as shown.
Connect "L" and "R" AUDIO OUT terminals on Playing VCR to "L" and "R" AUDIO IN
terminals on Recording VCR. (VHQ-451
Rear)
Connect AUDIO OUT terminal on Playing VCR to AUDIO IN terminal on Recording VCR.
(VHQ-401
Rear)
In place of a Playing VCR, you can use other equipment, such as a Camcoder.
Simply connect the unit's Audio/Video outputs to the Recording VCR.
Playing (Source) VCR
1
Insert pre-recorded
tape.
2
Press PLAY, then PAUSE/SLOW
immediately to enter PLAY/PAUSE mode.
Recording (Editing) VCR
Insert blank tape with record tab.
Press INPUT to set VCR Input mode to LINE
for Video Input. (See "Selecting the Input
Mode" below.}
Press REC, then PAUSE/SLOW
immediately to enter REC/PAUSE
mode.
The operation of steps 4 and 5 must be done on both
playing and recording VCRs at the same time.
Press PLAY to start dubbing.
Playing VCR starts playback.
5
Press STOP to stop dubbing.
E To Monitor Dubbing on Your TV
1 Tum your TV on and tune to the Recording
VCR channel (CH3 or CH4),
2 Set the VCR/ TV Selector on the Recording
VCR to "VCR."
MO
Dubbing tapes protected with Copy Guard will
have poor quality results.
Press PAUSE/SLOW to start dubbing.
Recording VCR
starts recording.
Press STOP to stop dubbing.
E Selecting Input Mode
Method 1,
-->press INPUT to switch between channel number and
LINE.
Method 2,
-->press CH á / ¥ to change display as follows.
1462423
(
(CABLE)
(TV)
)
LINE+—+
125
or
69
* "L" lights about 4 sec. on front panel when LINE is
selected.
Caution: Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.
For assistance, please call : 1-800-211-PANA(7262} or send e-mail to ; consumerproducts@panasonic.com
Advertisement
Table of Contents
