Getting Started - Yamaha HTR-6040 Owner's Manual

■ Checking the supplied accessories
Check that you received all of the following parts.
Remote control
Batteries (2)
(AA, R06, UM-3)
CODE SET TRANSMIT
POWER POWER STANDBY POWER
TV AV
MD MULTI CH IN AUDIO SEL
CD CD-R
CBL
DVD DTV TUNER XM
DOCK
V-AUX DVR
AMP
SOURCE
TV VOL TV CH VOLUME
TV
TV MUTE TV INPUT MUTE
MUSIC ENTERTAIN MOVIE STEREO
1 2 3 4
ENHANCER STRAIGHT DIRECT ST.
5 6 7 8
Optimizer
SUR. DECODE NIGHT SLEEP
9 0 +10 ENT
microphone
PRESET/CH
LEVEL SET MENU
TITLE MENU
BAND SRCH MODE
ENTER
A-E/CAT.
RETURN DISPLAY
XM MEMORY
REC
SCENE
1 2 3 4
Note
The form of the supplied accessories varies depending on the
models.
■ VOLTAGE SELECTOR
(Asia and General models only)
Caution
The VOLTAGE SELECTOR on the rear panel of this
unit must be set for your local voltage BEFORE
plugging the power cable into the AC wall outlet.
Improper setting of the VOLTAGE SELECTOR may
cause damage to this unit and create a potential fire
hazard.
Select the switch position (upper or lower)
according to your local voltage using a straight
slot screwdriver.
Voltages are 110-120/220-240 V AC, 50/60 Hz.
VOLTAGE
SELECTOR
110V-
120V
220V-
240V

Getting started

■ Installing batteries in the remote control
AM loop antenna
Indoor FM antenna
1
2
3
Notes
• Change all of the batteries if you notice the following
conditions:
– the operation range of the remote control decreases.
– the TRANSMIT indicator does not flash or its light becomes
• Do not use an old battery and a new one together.
• Do not use different types of batteries (such as alkaline and
manganese batteries) together. Read the packaging carefully as
these different types of batteries may have the same shape and
color.
• If the batteries have leaked, dispose of them immediately. Avoid
touching the leaked material or letting it come into contact with
clothing, etc. Clean the battery compartment thoroughly before
installing new batteries.
• Do not throw away batteries with general house waste; dispose
of them correctly in accordance with your local regulations.
• If the remote control is without batteries for more than 2
minutes, or if exhausted batteries remain in the remote control,
the contents of the memory may be cleared. When the memory
is cleared, insert new batteries and set up the remote control
code.
1
3
2
Take off the battery compartment cover.
Insert the two supplied batteries
(AA, R6, UM-3) according to the polarity
markings (+ and –) on the inside of the
battery compartment.
Snap the battery compartment cover back
into place.
dim.
Getting started
3
En