Hydraulic System; Point Hitch Control System; Operating The 3-Point Hitch Control / Cutting Height Adjustment Lever To Raise Or Lower The 3-Point Hitch - Cub Cadet Yanmar SC2400 Operator's Manual

11. HYDRAULIC SYSTEM

WARNING
ALWAYS fully release the internal
hydraulic pressure before
disconnecting a hydraulic line.
ALWAYS ensure that all
connections are tight and all the
hydraulic lines, pipes and hoses are free from wear
or damage.

1. 3-Point Hitch Control System

IMPORTANT:
●NEVER operate the 3-point hitch control / cutting
height adjustment lever before the engine has
been sufficiently warmed up.
●If the 3-point hitch control / cutting height
adjustment lever is operated before the engine has
been warmed up, the hydraulic system can be
damaged or develop a failure.
●If abnormal hydraulic noise occurs after the 3-point
hitch has been raised, then misadjustment or failure
of the hydraulic system should be suspected.
In such a case, immediately stop operation and
request your local Cub Cadet Yanmar dealer to
service or repair the tractor.
■ Operating the 3-Point Hitch Control / Cutting Height Adjustment Lever to Raise or
Lower the 3-Point Hitch
Use the 3-point hitch control / cutting height
adjustment lever, when raising or lowering the Mid-
or Rear-mounted implement.
1. Shift the 3-point hitch control / cutting height
adjustment lever to the intended position.
2. Adjust the position stop knob to set the lowest
position of the implement to the desired height.
(A) 3-point hitch control / cutting height
adjustment lever
(B) Position stop knob
(a) Moving the 3-point hitch control / cutting height
adjustment lever forward will lower the
implement.
(b) Moving the 3-point hitch control / cutting height
adjustment lever backward will raise the
implement to raise higher.
11. HYDRAULIC SYSTEM
3014918c
11-1
(a)
(B)
Sc2400 Operator's Manual
(A)
(b)