Rack-Mounting By Using Only Front Mounting Brackets - HP 5120 EI Series Installation Manual

Figure 31 Rear mounting bracket
(1) Hole for attaching to a rack (by using an M6 screw)
NOTE:
The M6 screws for fixing the brackets to a rack are user supplied.
Table 7 shows the mounting bracket shipment for different switch models.
Table 7 Mounting bracket kit shipped with the 5120 EI switches
Chassis
5120-24G EI (2 slots)
5120-24G EI TAA (2 slots)
5120-48G EI (2 slots)
5120-48G EI TAA (2 slots)
5120-24G EI
5120-48G EI
5120-24G-PoE+ EI (2 slots)
5120-24G-PoE+ EI TAA (2 slots)
5120-48G-PoE+ EI (2 slots)
5120-48G-PoE+ EI TAA (2 slots)

Rack-mounting by using only front mounting brackets

This installation method is available only for the 5120-24G EI (2 slots), 5120-24G EI TAA (2 slots),
5120-48G EI (2 slots), 5120-48G EI TAA (2 slots), 5120-24G EI, and 5120-48G EI switches.
This task requires two persons.
To mount a switch in a 19-inch standard rack by using only the front mounting brackets:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
1.
grounded.
Check that the rack is well grounded and can support the weight of the switch chassis and all its
2.
accessories.
Front mounting brackets
One pair
One pair
18
Rear mounting brackets
N/A
One pair