Installation Procedure - HP 5120 EI Series Installation Manual

Figure 55 Magnet mounting kit
(1) M3*6 countersunk head screw

Installation procedure

To complete magnet mounting:
Use a Phillips screwdriver to pass the countersunk head screw through the round hole at the center
1.
of the permanent magnet, fasten it to a blind nut in the dent of the switch bottom, and make sure
that the permanent magnet and the switch are fastened reliably. See
NOTE:
Remove the cushion, if any, from the dent before installation.
•
To ensure the firmness of installation, be sure to use four permanent magnets to secure each switch.
•
Attach the magnet-mounted switch to the specified location. Do not get your fingers stuck between.
2.
Figure 56 Magnet mounting
1 2
(1) M3*6 countersunk head screw
(3) Blind nut in the dent of the switch bottom
(2) Permanent magnet
3
(2) Permanent magnet
33
Figure 56.