Table of Contents
Advertisement
| Warning:
This
device complies with Part 15 of the FCC Rules, Operation is subject to
the
following
I
two conditions: (1)
This
device may not cause harmful interference, and (2) this device must accept
i
any interference received, including interference that may cause undesired operation.
!
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
|
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro-
j
lection against harmful interference in a residential installation. This equipment generates, uses, and
|
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
|
may cause harmful interference to radio communications. However, there is no guarantee that inter-
I
ference will not occur in a particular installation. If this equipment does cause harmful interference
j
to radio or television reception, which can be determined by turning the equipment off and on, the
1
user is encouraged to try to correct by one or more of the following measures:
— Reorient or relocate the receiving antenna.
—- Increase the separation between the equipment and receiver.
—■ Connect the equipment into an outlet on a circuit different from that to which the receiver is con¬
nected.
— Consult the dealer or an experienced radio /TV technician for help.
Caution to the user:
Changes or modifications not expressly approved by the manufacture could
void the user's authority to operate the equipment.
Notes
Before using:
This Digital
8
camcorder uses Hi 8/Digital
8
tapes with a Hi i I
|
) mark and records
in. the Digital 8 B format. This camcorder also can play back pictures on tapes recorded by other
HilB and 0 camcorders. For more smoothly recorded pictures, it is recommended that you do not
mix images recorded in these Hi 0 and 0 formats, with Digital 8 B format on the same tape.
Note that this camcorder cannot play back Hi8/8 format tapes recorded in the LP mode.
Hi!D/D is a trademark of Sony Corporation.
MOISTURE
Avoid operating your camcorder immediately after moving it from a cold place to a warm, humid
place. Give the camcorder 2 to 3 hours to stabilize in the ambient conditions of the surroundings
before inserting a cassette. When moved from a cold place to a warm, humid place, moisture may
condense on the head drum inside the machine. This moisture could cause the tape to stick to the
headwheel and damage the headwheel or tape.
When a small amount of moisture is sensed, "TAPE" flashes in the viewfinder or on the LCD moni¬
tor. Remove the cassette and set the CAM/OFF/VIDEO switch to OFF, then wait for about one
j
hour.
VM-D965LA/VM-D865LA
E3
Advertisement
Table of Contents
