Kenmore 68610/1 Owner's Manual page 7

Removing and replacing the microwave oven
If you need to remove your Microwave Hood Combi-
nation for any reason, follow these simple steps:
5. Grasp the microwave oven. Rotate the microwave
oven downward. (Be
careful that door does
not swing open.) Lift off
the support tabs _ at
the bottom of the mount-
ing plate. Set the micro-
wave oven aside on a
protected surface.
To remove:
1.
Unplug microwave oven or disconnect power.
2. Remove filters and vent grille.
• If filters O are
installed, push in at the
tab and slide filter to the
outside edge to remove.
• Remove the two
screws O from the top
of the microwave oven
cabinet (the screws
located closest to the
front corners). Do not
remove the screws
located towards the center of the cabinet.
• Remove the vent grille _. Set the screws and
grille aside. (If grille cannot be removed, see pt. 4.)
3. After removing all oven contents, including the
turntable and support,
tape the door in the
closed position. Then
remove the two bolts
securing the
microwave oven to the
upper cabinet.
/ H
H "4
I<-
4, Hold microwave hood combination in place with
in pt. 2.), insert a thin
looped wire or similar
tool through an opening
in grille to pull hook.
one hand. Pull hook
to release microwave
hood from mounting
plate. If grille cannot be
removed (per instructions 5. Untape the door and replace the turntable and
support.
6. Replace the vent grille.
7. Replace the two screws in the top of microwave
oven cabinet (the screws located closest to front
corners).
8. Re-install filters (see "Installing and caring for the
filters" in the "Caring for Your Microwave Oven"
section, if needed).
To replace:
1. Carefully lift microwave oven and hang it on the
support tabs at the bottom of the mounting plate.
2. Rotate the front of the microwave oven cabinet
downward. Thread the power supply cord through
the power supply cord hole in the bottom of the
upper cabinet.
3. Rotate the microwave oven towards the cabinet.
Push the microwave oven against the mounting
plate until locking latch snaps into the cabinet.
4. Replace the two bolts securing the microwave
oven to the upper
cabinet.
9. Plug in microwave oven or reconnect power.
7