Technics SC-CH750 Operating Instructions Manual page 74

Concerning the Display
The spectrum analyzer shows the level of each sound range with
four types of display described below. ([4] appears only when you
select the V. BASS mode.)
Press DISPLAY momentarily.
DISPLAY
c=
Each time you press DISPLAY, the spectrum display will change as
follows.
[1] Bar-type display
This display indicates the strength of the sound in each tonal range.
[2] Peak-hold display
The peak sound value of each sound range remains on the display
for about 1 second after it occurs.
[3] Aurora display
The peak sound value of each sound range appears in inverted
form.
TTT oe
DISPLAY
a
[4] V. Bass-mode display
This display appears only when you select the V. BASS mode.
(See page 60.) It shows the strength of the augmented bass level.
Note:
When you press V. BASS to ON in any display modes, the bar-type
display will be switched to appear.
@ To display the equalization curve together with
the spectrum analysis display
Press and hold DISPLAY.
DISPLAY
one |
The equalization curve will appear.
To resume the previous mode, press and hold DISPLAY once
again.