Band Edge Beeper; Smart Search Operation; Setting The Smart Search Mode; Storing Smart Search Memories - Vertex Standard VX-110 Operating Manual

The VX-110 will automatically "beep" when a band edge is encountered during scanning
(either in standard VFO scanning). You may disable this feature, if it is annoying, without
disabling the keypad beeper (the default condition for this feature is "ON".
The procedure for disabling the Band-Edge Beeper is:
Press the [ F ] key, then press the [ M/V ( SET ) ] key, to enter the Set mode.
Rotate the DIAL to select Menu #16 ("
Press the [ F ] key to enable changing of this Menu item.
Rotate the DIAL to set this Menu item to OFF.
When you have made your selection, press the PTT key to save the new setting and exit
to normal operation.
The Smart Search feature allows you to load frequencies automatically according to where
activity is encountered by your radio. When Smart Search is engaged, the transceiver will
search above and below your current frequency, storing active frequencies as it goes (with-
out stopping on them even momentarily); these frequencies are stored into a special Smart
Search memory bank, consisting of 31 memories (15 above the current frequency, 15 be-
low the current frequency, plus the current frequency itself).
Two basic operating modes for Smart Search are available:
: In this mode, the transceiver will sweep the current band once in each direc-
tion starting on the current frequency. All channels where activity is present
will be loaded into the Smart Search memories; whether or not all 31 memo-
ries are filled, the search will stop after one sweep in each direction.
: In this mode, the transceiver will make one pass in each direction as with
One-Shot searching; if all 31 channels are not filled after the first sweep,
however, the radio will continue sweeping until they are all filled.

Setting the Smart Search Mode

Press the [ F ] key, then press the [ M/V ( SET ) ] key, to enter the Set mode.
Rotate the DIAL to select Menu #29 ("
Press the [ F ] key to enable changing of this Menu item.
Rotate the DIAL to select the desired Smart Search mode (see above).
When you have made your selection, press the PTT key to save the new setting and exit
to normal operation.

Storing Smart Search Memories

Set the radio to the VFO mode.
Press the [ F ] key, then press the [ M/V ( SET ) ] key, to enter the Set mode.
VX-110 O
PERATING
B E
AND DGE
S S
MART EARCH
M
ANUAL
B
EEPER
").
O
PERATION
").
Scanning
23