Inserting The Batteries. 1-6 (En); Turning The Video Transmitter On; Turning The Video Transmitter Off - Sony RSE-500 Operating Instructions Manual

ommander (Only for RSE-500)
■
n
rransmitter On an
aw
inserting the Batteries
1
Remove the battery cover.
2
Insert two size AA (LR6) alkaline batteries with
their polarities correctly aligned.
Caution
Be sure to install the negative © end of the battery
in first. If you place the positive © end in first,
there is a possibility of damaging the insulated film
covering the battery and creating a short circuit.
O Replace the cover.
Battery life
When the batteries become weak or dead, the Remote
Commander does not function.
Notes on batteries
To avoid possible damage from battery leakage or
corrosion, observe the following.
• Be sure to insert the batteries in the correct direction.
• Do not mix old and new batteries or different types ot
batteries.
• Do not attempt to charge dry-cell batteries.
• If you do not intend to use the Remote Commander
for a long time, remove the batteries.
If battery leakage occurs, clean the battery
compartment and replace all the batteries.
Turning the Video Transmitter On
1
Turn on the devices connected to the Video
Transmitter.
2
Press the POWER switch.
The Video Transmitter turns on and the POWER
lamp (green) lights up.
After the initial screen is displayed, the DIAL
LIST menu appears.
You can call the remote sites registered on this
DIAL LIST menu.
-DIPL LIST-
1
2
.
3 .
4 .
5 .
6
.
7 .
8
.
9 .
1 0
.
<♦>
<♦> <EXIT> I<D1QL>
To go to the main menu
Move the cursor to <EXIT> using
♦,
^
or ♦, then
press ENTER.
If you are not going to use the unit for a long time, tui
off the POWER switch.
Turning the Video Transmitter Off
Press the POWER switch.
The Video Transmitter is turned off and the POWER
lamp goes off.
Cautions
' Do not turn off the power when you are setting an
item in the SETTING menu. It may damage the
registered data.
•The line may not be used temporarily if you turn of!
the power during communications.