Installing The Display Assembly - Dell Inspiron 5598 Service Manual

Steps
1. Peel the tape that secures the display-cable connector to the system board.
2. Open the latch and disconnect the display cable from the system board.
3. Remove the four screws (M2.5x5) and the two screws (M2x4) that secure the left and the right display hinges to the palm-rest and
keyboard assembly.
4. Open the display hinges at an angle of 90 degrees.
5. Gently slide and lift the palm-rest and keyboard assembly off the display assembly.

Installing the display assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation procedure.
42 Removing and installing components