Table of Contents
Advertisement
indoor unit.
1. Remove the air inlet grille.
Open the air inlet grille upward and pull it toward you.
2. Remove the terminal cover and the clamp base.
3. Insert the control wire fully into the control/wired remote controller terminal block and secure it tightly
with screws.
the control/wired remote controller terminal block.
6. Install the clamp base with a screw.
7. Insert the power supply wire fully into the terminal block and secure it tightly with screws.
Tightening torque: 1.2 N·m (0.12 kgf·m)
Secure the earth line with the earth screw.
8. Clamp the power supply wire with the cord clamp.
Secure the earth line with the earth screw.
11. Attach the terminal cover, the front panel and the air inlet grille to the indoor unit.
Control wire
from the
terminal cover.
23-EN
Terminal
block for
control/wired
remote
controller
wiring
Control wire
Power supply wire
Connector
Cord clamp
CAUTION
– 23 –
Installation Manual
Power supply
terminal block
Earth screw for
Cord clamp
Power supply wire
Advertisement
Table of Contents
