Locking The Transit Restraint - Xerox Phaser 340 Supplementary Manual

Locking the transit restraint

Refer to the following illustration while performing these steps.
1. When the printer displays the Ready message, power it down
using the rear-panel On/Off switch. The printer places the print
head in the locking position.
Caution
2. Locate the transit restraint on the right side of the printer and
insert a wide flat-blade screwdriver into the transit restraint slot.
To avoid damaging the printer's internal components, always
turn the printer power off and lock the transit restraint before
moving the printer. Failure to do so may result in damage to
the printers' internal components and may invalidate your
printer's warranty.
3
2
9101-51