Table of Contents
Advertisement
5-1
1
2
3
4
5
46 • Chapter 5
Installing a SIMM
Follow this procedure for installing a memory SIMM to increase
printer memory.
Turn the printer power OFF and unplug the printer power cord.
Disconnect all cables from the back of the printer.
Open the front cover and remove the image cartridge. Refer to
"Replacing the Image Cartridge" on page 41).
Push down on the tray and stacker extenders until both are
recessed into the printer body.
Turn the printer upside down, remove the screws where shown
below, and remove that half of the bottom panel (1).
The printer's control board and the SIMM are sensitive to static
electricity. Before installing the SIMM, discharge static electricity
from your body by touching something metal, such as the metal
back plate on any device plugged into a grounded power source.
If you walk around before completing the installation, again
discharge any static electricity.
Advertisement
Table of Contents
