Pioneer CX-J400 Series Operating Instructions Manual

The Art of Entertainment
TUNER CONTROL AMPLIFIER
AMPLIFICATEUR DE COMMANDE TUNER
Operating Instructions
Mode d'emploi
STEREO POWER AMPLIFIER
AMPLIFICATEUR DE PUISSANCE STEREO
M-J200/M-J300
SOUND IMAGE CONTROLLER
CONTROLEUR D'IMAGE SONORE
GR-JSOO0O/GR-J400
STEREO DOUBLE CASSETTE TAPE DECK
DOUBLE PLATINE CASSETTE STEREO
CT-J200WR/CT-JSOOWR .
AUTO-RETURN STEREO TURNTABLE
TABLE DE LECTURE STEREO A RETOUR AUTOMATIQUE
PL-J400/PL-J500
* The CX-J400 is for Europe only.
** The CX-J500 is sold outside U.K., Europe, and Australia.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
FM/AM CHANNEL SWITCH
This switch is not provided on models for Europe, U.K. or Australia.
Adjustment is only necessary when there is a CHANNEL STEP
switch at the rear pane! on the tuner control amplifier.
The CHANNEL STEP switch is located on the rear pane! of the tuner
control amplitier. Before the tuner control amplifier leaves the factory,
this switch is set to the channel step standard of the area where
the tuner contro! amplifier is sold.
Depending on the position of this switch, each time TUNING button
is pressed, the frequency display changes by the following amount:
{100 kHz/10 kHz] position
For areas with channel step of 100 kHz for FM and 10 kHz for AM.
{50 kH2/9 kHz} position
For areas with channel step of 50 kHz for FM and 9 kHz for AM.
NOTE:
Hf the switch is set to the wrong position, correct tuning may not |
be possible,
Consult your dealer if you are not sure about the radio channel |
step standard in your area. j
English
Francais
* Le modéle CX-J400 n'est destiné qu'a !'Europe.
"* Le modéle CX-J500 est vendu a !'extérieur du Royaume-Uni, de
Europe et de |' Australie.
{For tuner control amplifier and stereo power amplifier)
LINE VOLTAGE SELECTOR SWITCH
Only multi voltage models are provided with this switch. European,
U.K., and Australian models are not provided with this switch.
Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use
this model with 110 V setting in Saudi Arabia.
Before your model is shipped from the factory, this switch is set to the
power requirements of the destination; nevertheless, you should check
that it is set properly before plugging the power cord into the AC outlet.
1. Disconnect the power cord.
2. Use a medium-size screwdriver.
3. insert the screwdriver into the groove on the voltage selector and
adjust so that the voltage value of your area.
220% v 24ov
340¥ 12Ov-1270