Xerox DocuPrint 100 User Manual page 103

Stock type
Letterhead
Manual two-sided (duplex)
prints
Textured paper
a. You can order a mylar reinforcement tray which allows a feeder tray to handle up to 500 sheets
of this type of stock. Contact your service representative for additional information.
Paper Superior performance
Size 8 by 10 to 11.69 by 17
a inches /203 by 254 to 297
range
by 432 mm
Weight 20 to 110 pounds or 80 to
range 200 gsm
Capacity
Stack • Xerographic paper in
quality good condition
• 20 pound or 80 gsm
and heavier stock
• Very low to no output
curl
System Overview Guide
Table B-4. Paper stocks guide (Continued)
Instructions for use
• Load into trays with side 1 UP and top edge toward the front of the
tray (avoid placing the print in line with the feed belt in trays 1 and
2).
• Avoid using freshly preprinted paper.
• Load into trays with printed side DOWN and top edge toward the
front of the tray (avoid placing the print in line with the feed belt in
trays 1 and 2).
• Print the second side as soon as possible after the first side to
prevent wrinkling and excessive curl.
Heavily textured paper may yield prints with ragged character
appearance and/or deletions. To test, print a sample sheet.
Table B-5. Stacker bin performance guide
Good performance
Lighter than 20 pounds
or 80 gsm and no lighter
than 16 pounds/60 gsm
• Lighter weight
stocks with low
output curl
• Intermixed stocks
Paper performance guidelines
Performance limits and
suggested alternatives
Smaller or larger sizes cannot
be used.
Weights outside the limits
shown here are not
recommended.
• Capacity automatically
limited so stack weight will
not exceed 30 lbs/13.g kg
• Selectable with bin
capacity programming
(Refer to the "Bin full
criteria and setting bin
limits" section of the
"Status and print tasks"
chapter for instructions.
• Adjust process decurler
• Flip paper in paper feeders
• Limit stack capacity to
acceptable limits.
B-5