Cable Locations - Xerox DocuColor 2060 Installation Planning Manual

System connections

Cable locations

7-2
Using an inappropriate alternate cable may degrade the
performance of your equipment and may also be hazardous.
NOTE: Cable length loss must be factored in if equipment is
installed in a raised-floor environment. You should also consider
that part of the length of a cable is routed inside the equipment to
connect with interior power or data receptacles.
To run the cables beneath the flooring effectively, it is necessary
to know where the cables enter and exit the printer. The following
diagrams show those locations (marked with an X).
All power cords attach to the back of the printer. Listed below are
the distances of the printer power cord attachments from the left
end of the printer as you face it.
1
2
Figure 7-1. Cable enter/exit location (top view)
1. Back of system
2. Front of system
WARNING
4"/10 cm
x
4"/10 cm
Installation Planning Guide