Powering on
Circuit
breaker
switch
Printer
power
switch
XES SYNERGIX 8850 PRINTER OPERATOR MANUAL
2.
This chapter describes the procedures for powering on and
powering off. It also describes the power consumption modes.
To power on:
1. Switch the circuit breaker to the On (I) position. This turns on
power to the AccXES controller. The AccXES controller does
not have a separate power switch.
2. Switch the printer power switch to the On (I) position. This
turns on power to the printer.
NOTE: During the warm-up cycle, the message display
provides a "printer is warming up" message and decreasing
fuser warm-up codes of L9 to L0. When the warm-up
completes, the printer is on-line and ready to print. The
message display indicates, "XES SYNERGIX 8850 IDLE."
Powering on and off
7