Clearing Media Jam (J-04) - Xerox 721 Operator's Manual

PROBLEM SOLVING

Clearing Media Jam (J-04)

Fuser
Handle
Cutter
handle
Inner Transport handle
Slit
Cutter
38
When a jam J-04 occurs, the media jams while feeding from Roll 4
in the bottom drawer.
MF
1. Open the bottom drawer.
2. Open the Right Side Door and turn the Inner Transport
3. If the media is not cut and the leading edge of the media has
4. If the leading edge of the media has reached the Fuser Unit,
Down Lock
5. Release the Down Lock while holding the handle of Inner
6. Manually rewind the roll until the lead edge of the media is free
7. Trim the lead edge of the roll square to remove any torn or
8. Insert the lead edge of the media between the upper and
9. Rotate the green knob in the clockwise direction in order to
10. Press the [Online] Key to take the printer Offline (LED Off).
11. Push in the drawer until it is closed and latched. If the leading
Green Knob
Exit
D1
PF
D2
D3
D4
Assembly handle to release the transport. Lower and lock the
transport by engaging the Down Lock.
reached the Drum or beyond the Drum, rotate the Cutter
handle to cut the media. Continue rotating the cutter handle
so that the green home position indicator appears in the cut
out.
open the Exit Cover and remove the jammed media by rotating
the Fuser Handle.
Transport Assembly and lift it up gently until it stops. Then
twist the handle to the left to move the transport to the home
position. Finally, turn the handle to the right to lock the
transport.
of the feed rollers.
wrinkled media by using the "Slit" if necessary.
lower feed rollers.
feed an inch of media between the feed rollers.
edge is not sufficiently square, perform the automatic Initial
Cut by pressing the [Select] key to select the appropriate
drawer, and then pressing [Cut] key. Approximately 9.5"
(240mm) media will be cut and fed from the printer.
XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL
Copy Density
Menu Enter Online