Xerox WorkCentre Pro 16p User Manual page 17

Control Panel
6. Variable Percentage: Press the down key to decrease the percentage. Press the up key to
increase the percentage. Any percentage from 50% to 200% may be selected.
7. %: Press this key to display the reduction/enlargement percentage selected.
8. Display Window: Copy quantity, reduction/enlargement settings, and status codes appear in
this area.
9. Quantity Keys: Select up to 100 copies. Press the 1 key to increase the quantity by one.
Press the 10 key to increase the quantity by 10.
To display the number of copies requested during the copy run press the 10 key.
Press the Clear key to clear the selected quantity.
10. Pro 16p Diagram: Helps you locate areas that require your attention. The indicators will
flash in the area requiring attention. For additional information refer to the Problem Solving
section.
11. Paper Supply Selection: Press to change the selected paper supply. The selected paper
supply location will be indicated by a green light on the Pro 16p diagram.
12. ADF Misfeed Indicator: This indicator will light when a misfeed occurs in the ADF.
13. On-line/Off-line Key: Press this button to alternate between On-line and Off-line status.
When the light is lit, the printer is On-line.
14. Data LED: This LED indicates the processing of electronic data in the Pro 16p PCL
Controller. The LED is ON when the Pro 16p is printing documents. The LED is OFF when
no data is present. The LED is blinking when the Pro 16p is receiving data sent to the printer.
15. Ready Indicator: When the light is ON (not flashing), the Pro 16p is ready to make copies.
When the light is flashing after the Start key is pressed, the Pro 16p is warming up and the
copy cycle will begin automatically.
16. Start: Press this key to begin copying.
The display will change to 1 and increases by 1 as each copy is made.
17. Clear/Stop: Press this key to stop the Pro 16p while making copies or to clear copy quantity.
If the key is pressed twice quickly, all programming will be cleared.
11