Xerox WorkCentre M123 Quick Network Setup Manual
Hide thumbs
Also See for WorkCentre M123:
- User manual (364 pages) ,
- System administration manual (168 pages) ,
- Quick reference manual (154 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Xerox WorkCentre M123
Summary of Contents for Xerox WorkCentre M123
- Page 1 Quick Network Setup Guide WorkCentre M123/M128 WorkCentre Pro 123/128 701P42078...
- Page 2 See the About License section for detailed information on licensed products. The information in this document is correct at the time of publication. Xerox reserves the right at any time to change the information without notice. Changes and technical updates will be added in subsequent editions of the...
- Page 3 Table of Contents QUICK NETWORK SETUP (DHCP) .............4 TCP/IP:........4 REQUISITES FOR QUICK ETWORK ETUP USING M123/M128 IP DHCP:..........4 ONFIGURING ADDRESS VIA TCP/IP:........4 ROCEDURE FOR QUICK ETWORK ETUP USING QUICK NETWORK SETUP (STATIC IP) ............5 IP A :...6 ROCEDURES FOR MANUAL SETUP OF NETWORK USING TATIC DDRESS Page 3 of 7...
-
Page 4: Q U I C K N E T W O R K S E T U P ( D H C P )
2. Confirm that the Ethernet cable is plugged into the M123/M128 and into an operational Ethernet port on the network. NOTE: The Ethernet cable is an RJ45 type and is not supplied by Xerox Configuring M123/M128 IP address via DHCP: On startup, the M123/M128 Multifunction device defaults to DHCP to obtain its network configurations. - Page 5 Figure 1 CentreWare Internet Services is a powerful tool for configuring the M123/M128 device remotely. The default user name is “x-admin” and password is “11111”. These should be changed after install Step 4 : Load the Print Drivers on the workstations that will be accessing the M123/M128 device. For more detailed instructions, see the System Administrator Guide.
- Page 6 Procedures for manual setup of network using Static IP Address: Step 1 : Power on the M123/M128 device. Step 2: Select on “Login/Logout”. Enter the UserID (11111). Select “System Settings” “System Settings” “Network Settings” Protocol Settings. Step 3 : Select “IP address” and Press “Change Settings”. Enter the IP address of the machine.
- Page 7 Figure 2 : CentreWare Internet Services is a powerful tool for configuring the M123/M128 device remotely. The default user ID is “11111” and password is “x-admin”. These should be changed after install. Page 7 of 7 701P42078...