Installing Exhaust Pipe - Miller Wildcat 200 Owner's Manual

5-2. Grounding Generator To Truck Or Trailer Frame

5-3. Installing Exhaust Pipe

1 2
GND/PE
3
.
A complete Parts List is available at www.MillerWelds.com
!
!
!
!
1
2
3
Connect cable from equipment
ground terminal to metal vehicle
frame. Use #10 AWG or larger
insulated copper wire.
.
!
Engine backfire can cause se-
vere burns or other injuries. Do
not point exhaust pipe toward
control panel. Keep away from
exhaust outlet.
!
Point exhaust pipe in desired
direction but always away from
front panel and direction of
travel.
.
Be sure to tighten exhaust clamp
nuts. Exhaust clamp is supplied
with unit.
Always ground generator
frame to vehicle frame to pre-
vent electric shock and static
electricity hazards.
Also see AWS Safety &
Health Fact Sheet No. 29,
Grounding of Portable And
Vehicle Mounted Welding
Generators.
Bed liners, shipping skids,
and some running gear insu-
late the welding generator
from the vehicle frame. Al-
ways connect a ground wire
from the generator equip-
ment grounding terminal to
bare metal on the vehicle
frame as shown.
If unit does not have GFCI re-
ceptacles, use GFCI-pro-
tected extension cord.
Equipment Grounding
Terminal (On Front Panel)
Grounding Cable (Not
Supplied)
Metal Vehicle Frame
Electrically bond generator
frame to vehicle frame by met-
al-to-metal contact.
rot_grnd 2008-01 − 800 652-D
Tools Needed:
1/2 in.
805 254 / 801 681
OM-237 711 Page 21