Set Up Options - Xerox Document Centre 220 Getting Started

Set Up Options

There are two procedures that can be used to successfully set up
scanning. Read the information below and choose the procedure
that you will use to complete the installation:
l
l
Output Image Quality
l
Page 2 - 2
Set Up Scanning
To complete the native implementation of scanning for your
NetWare environment, go to the section of this chapter titled Set
Up Scanning now.
Use Xerox CentreWare Internet Services
Xerox's CentreWare Internet Services is accessed through the
embedded HTTP server on the DC220/230/332/340ST that
allows System Administrators and users to configure scan
settings. This is accomplished by using an Internet browser such
as NetScape (version 3.x or later) or Microsoft Internet Explorer
(version 4.x or later).
Using Internet Services, you can:
l
Create new scan templates
l
Update existing scan templates
l
Modify scan configurations (including document repository
locations), enable and disable Confirmation Sheets, and
change Filing Protocols.
l
Enable Multi-Page TIFF, which will create a single TIFF
file for a multi-page document, instead of one TIFF file for
each page
Multi-Page TIFF can be enabled using Xerox CentreWare
Internet Services. When Multi-Page TIFF is enabled, a single
TIFF file will be created for a multi-page document. This
single TIFF file will contain all the pages of the document. An
.XSM folder is not created when scanning in the Multi-Page
TIFF mode. A single TIFF file and a log file (.xst) are stored in
the repository for each multi-page document that is scanned.
Companion to Getting Started with Scanning Services