Cub Cadet 108 Operator's Manual page 43

LUBRICATION GUIDE
International Cub Cadet 129, 149, and 169 Tractors
-Periodic
Once a year, apply two strokes of the lubricator, using I H
251 H EP grease or equivalent #2 multi-purpose lithium
grease.
9.
Steering gear housing.
NOTE: To locate the lubrication fitting, turn the front
wheels to the maximum right turn position. Then reach up
under the right side of the tractor frame to locate the
fitting.
Once a year, apply a few drops of oil (six or eight) around
the base of the control rod. When applying the lubricant
move the control rod from one extreme to the other for
more even distribution.
Speed Control Linkage
10. Speed control rod.
Once a year, apply a light amount of I H 251 H EP grease or
equivalent #2 multi-purpose lithium grease.
11. Cam plates
Lubricate the brake pedal shaft and linkage with eight or
ten drops of engine oil.
Miscellaneous
If the tractor is equipped with a Three-Point Hitch, once a
year the Lift Bar at the implement rockshaft should be
lubricated. Apply several strokes of I H 251 H EP grease or
equivalent #2 multi-purpose lithium grease.
REAR POWER TAKE-OFF
The power take-off shaft connection is a 15/16-
inch pitch diameter, ten-tooth involute spline with
a 30 degree pressure angle, machined for outside
diameter fit. The dimensions are shown.
Power take-off shaft governed
speed 515r.p.m.
Direction of rotation (looking at rear
of tractor) counterclockwise
Center line of power take-off shaft
above rear axle center of 3-1 /4-in.
Rear Power take-off shaft spline dimensions
(International Cub Cadet 86, 108, and
128 Tractors).
End of power take-off shaft to rear
of rear axle center line. 7-7/16-in.
41