Cub Cadet 108 Operator's Manual page 22

1. Float lockout pin (optional)2.
Hydrostatic drive unit3.
Cotter pin
The hydraulic lift is ready to operate when the
engine is running.
1. Hydraulic lift handle2.
Cam stop3.
Locking knob
OPERATING INSTRUCTIONS
The hydraulic control lever is spring loaded. To
raise the equipment move the lever back, toward
the tractor seat. To lower the equipment move the
lever forward, as shown.
NOTE: Remove or position cam stop on side of
frame for full travel of rockshaft before locking
rockshaft arm as previously described.
Equipment is normally operated in a "Float"
position (implement free to move upward) with
the lock pin (optional) positioned as shown.
NOTE: To avoid possible dam~ge, as soon as the
operation requiring "Down Pre,,~ure" is completed,
immediately return the float lockout pin to the
"Free to Float" position.
The cam stop may be adjusted as described on page
15 to allow the implement to return to a single
preset height.
To operate equipment in a fixed "locked" posi-
tion, where down pressure of the implement is
required (that is blade work), remove frame cover
and remove cotter pin in pivot pin. Reverse lock
pin (optional) and insert into pre-aligned holes in
clevis and lower portion of rockshaft arm. Replace
washer and cotter pin.
Refer to equipment manual for proper mounting
instructions.
NOTE: Periodically lubricate pin "A" and bushing
"B" with a few drops of engine oil in both
locations.
20