F - Maintenance; Filter Maintenance - Lincoln Electric AMBICLEAN 5000 Safety Instruction For Use And Maintenance

F - MAINTENANCE

FILTER MAINTENANCE

Pre-filter
Replacing the filter cassettes
-18
1 : Open the filter compartment
2 : Unscrew the 4 screws that hold the protective grille fastening
3 : remove the cassette
4 : Put the clogged cassette back in the packaging of the new cassette
5 : Install the new cassette, screw back the screws and put the grille back
6 : Apply the starting up procedure
Users are strongly advised to replace the cassettes as soon as the system ceases to
operate satisfactorily or an alarm indicates a system fault. (When extraction is no longer
adequate).
The AMBICLEAN ESSENTIAL 5000 uses filter cassettes with a unit filter surface of
42m², class EPA H13. Only original cassettes from LINCOLN ELECTRIC, part number
W000373568 provides the maximum efficiency of the filter.
From time to time (every week) as a preventive measure
or whenever the extraction no longer seems adequate:
Clean with compressed air in a very well ventilated room
or by immersion in a solution of water + FILTERCLEAN
20L part no. W000261362 and dry with air (dilution
depending on fouling, see label on drum).
Access to the pre-filters is through the air inlet.
NB: To replace the cassettes, always use protective
goggles and a respiratory mask in order to prevent any
risk of contact with or inhalation of the particles collected.
The power supply must always be switched off using the
disconnector or via the fuses. If the filter has a power
connector, it must be separated from its socket on the
wall.
8695 8472 / A
AMBICLEAN 5000