Mouse Operation - X10 Big Picture VK25A Owner's Manual

M O
OUSE PERATION
The Mouse Remote sends wireless RF signals (from up to 100 ft.
away) to the receiver which built-in to the VT24A Video Sender.
These signals are sent to the VGA to video converter (VA23A) which
passes them on to your PC's mouse port (see diagram on page 10).
To install the Mouse Receiver:
First shut down and turn off your PC. Unplug your mouse and connect
the Mouse OUT on the VA23A to your PC's serial mouse port (use the
enclosed adapter if you have a PS/2 port). Plug your existing serial
mouse into the socket on the VA23A (use the enclosed adapter if you
have a PS/2 mouse). Turn on your PC.
Note: you can only connect a serial mouse to the VA23A if you
connect its output to your serial port, or connect a PS/2 mouse to the
VA23A if you connect its output to a PS/2 port.
IMPORTANT: You cannot connect the Mouse Output on the VA23A
to a PS/2 port while the PC is turned on. If you try this, your PC will
not recognize your mouse. You can attach the output to a serial port
while the PC is turned on but you will then need to re-boot your
computer.
Now you can use the JR20A Mouse Remote as a wireless mouse. You
use the mouse pad on the front of the remote to move the cursor
around the PC screen, and use the buttons on the back of the remote
as the left and right mouse buttons. It's that simple!
Mouse pad
Left mouse button
Right mouse button
(on back) (on back)
29