Fine - X10 Big Picture VK25A Owner's Manual

F T V S
INE UNING YOUR IDEO ENDER
The Wireless Video Sender usually works best with the flat faces of
the antennas on the Transmitter and Receiver unit facing each other
(see diagram below). Sometimes, however, reflections and other
effects in the home may affect the signal so that some adjustment of
either the Transmitter or Receiver antenna may be necessary to get
the best the signal.
If you are not getting any signal at all: Check that the CHANNEL
slide switch (labeled 1 to 4) on both Video Sender units is set to the
same number. If you are using coaxial TV connections from the Video
Sender Receiver, check that the TV is connected to it is tuned to the
same channel as the TV Channel switch on the Video Sender (3 or 4).
I ,
F THE SIGNAL IS POOR OR THERE IS INTERFERENCE
Try changing the channel on both Video Sender units. Do this by
adjusting the CHANNEL slide switch on the side of each unit to any
position from 1-4. Make sure both units are set to the same channel.
19